
Fill the cavity embossment with water
only when the oven is cold.
CAUTION! Do not refill the
cavity embossment with
water during cooking or
when the oven is hot.
2. Put food in the oven and close the
oven door.
3. Set the function: .
4. Turn the control knob to select a
temperature.
5. Turn the knob for the heating functions
to the off position to turn off the oven.
6. Remove water from the cavity
embossment.
WARNING! Make sure that
the oven is cold before you
remove the remaining water
from the cavity
embossment.
CLOCK FUNCTIONS
Clock functions table
Clock function Application
TIME OF DAY To set, change or check the time of day.
DURATION To set how long the appliance operates.
END To set when the appliance deactivates.
TIME DELAY To combine DURATION and END function.
MINUTE MIND‐
ER
To set countdown time. This function has no effect on the op‐
eration of the appliance. You can set the MINUTE MINDER at
any time, also when the appliance is off.
Setting the time. Changing the
time
You must set the time before you operate
the oven.
The flashes when you connect the
appliance to the electrical supply, when
there was a power cut or when the timer is
not set.
Press the or to set the correct time.
After approximately five seconds, the
flashing stops and the display shows the
time of day you set.
To change the time of day press again
and again until starts to flash.
Setting the DURATION
1. Set an oven function and temperature.
2. Press again and again until
starts to flash.
3. Press or to set the DURATION
time.
The display shows
.
4. When the time ends, flashes and
an acoustic signal sounds. The
appliance deactivates automatically.
5. Press any button to stop the acoustic
signal.
6. Turn the knob for the oven functions
and the knob for the temperature to
the off position.
Progress 9
Komentarze do niniejszej Instrukcji