Progress PAG6430E-N Instrukcja Użytkownika Pobierz pdf (Strona 31)

A

5. If you change:

• from natural gas G25.3 25 mbar,

G25 25 mbar or natural gas G20 20

mbar to liquid gas, fully tighten the

bypass screw in.

• from liquid gas to natural gas G25.3

25 mbar, G25 25 mbar or natural

gas G20 20 mbar, undo the bypass

screw approximately 1/4 of a turn

(1/2 of a turn for Triple Crown

burner).

WARNING! Make sure the

flame does not go out when

you quickly turn the knob from

the maximum position to the

minimum position.

Electrical connection

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the

local power supply.

• This appliance is supplied with a mains

cable and a plug.

• Always use a correctly installed

shockproof socket.

• Make sure that there is an access to

the mains plug after the installation.

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug.

• There is a risk of fire when the

appliance is in connection with an

extension cable, an adapter or a

multiple connection. Make sure that the

ground connection agrees with the

standards and regulations.

• Do not let the power cable to heat up to

a temperature higher than 90° C.

Make sure that you connect the

blue neutral cable to the

terminal with a letter "N" on it.

Connect the brown (or black)

phase cable to the terminal

which has a letter "L". Keep the

phase cable connected at all

times.

Connection cable

To replace the connection cable use only

the special cable or its equivalent. The

cable type is: H05V2V2-FT90.

Make sure that the cable section is

applicable to the voltage and the working

temperature. The yellow / green earth wire

must be approximately 2 cm longer than

the brown (or black) phase wire.

Assembly

1.

2.

Progress 31

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

Komentarze do niniejszej Instrukcji

Brak uwag